Physical 3D Print

First Designs:

Cylinder Design:

1)

Modifications:
When considering what was required of this central pillar and evaluating the print time I decided to minimise it I shrank the design to x0.75 of the initial 40mm x 100mm design.
I also hollowed the base as I felt like that wouldn't sacrifice the structural integrity


Clips:


Initially I designed 2 different variations of the clip with different sized openings to experiment with the flexibility of the plastic and to see if it was capable of performing the "snapping" movement around the tube that I had designed without breaking. In regard to that determining how big the gap had to be to allow this friction. 

Physical Print: 

My first print was unsuccessful as I had uploaded each of the clips into separate planes. However in this iteration I found that the Brim I had designed was effective.


I then imported the designs from NetFabb to Cura as separate objects instead of together to prevent this happening again. 


My second print of the clips was successful and I discovered that the plastic is very flexible and the smaller hole is definitely preferable: for the next iteration will consider making the hole smaller again for more stability.
I also decided that my cylinder was unnecessary wide so in the next iteration I would make it slimmer.

Due to the success of the snapping ability with the clips I reconstructed my design for the central cylinder. The clips hugged the cylinder without sliding so I removed the "lip" at the top of the cylinder - as I remembered in the 3D printing orientation that this can cause issues with the plastic dropping down as there is no physical substance below it to prevent this occurring. -although I am aware I can put support in for this design I feel it isn't necessary to the design.



Third Print: 



I developed my design further to relate to my mood board by incorporating the branches off of the clip. The intention with these was to give the impression of veins-as this was a design structure hard to achieve with the Laser Cutter.  
I wasn't very happy with the finish of this print so I adapted the settings in Cura and used a different printer-however the design itself I was happy with.


Final Print: 

Support used for raised branches





Moving Forward:
Overall I'm happy with the outcome with this piece as I feel as though everything I struggled to achieve in the laser cut piece I could using this medium. However aesthetically moving forward I think I would make the design taller and thinner with more clips. Or give the design a functional purpose such as a pen holder and make it wider- or more branches to hold jewellery. I would also like to make the "branches" intersect through different planes-I only did this to one branch to a small degree min this piece but I think it would add more interest to the object.














Comments

Popular posts from this blog

Work Flow

Physical Trials

3D Print Experiments